[email protected]
of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of 7days, 14 days and 28 days.
waste marble powder construction industry itself as fine aggregate replacing natural sand in concrete. The replacement is done partially and fully in the proportion 0%, 25%, 50% and 100% and its effect on concrete properties were analyzed and outcomes that replacement of 50% of sand with marble powder is
river sand. Quarry dust and Marble powder contains similar properties as that of river sand and hence accepted as a building material. The present paper focuses on investigating maximum percentage replacement of river sand by Quarry dust and Marble powder in varying equal percentages 0%, 10%, 20%, 30%, 40%, 50%, and 60% for M25 mix designations.
Quarry dust and Marble powder contains similar properties as that of river sand and hence accepted as a building material. The present paper focuses on investigating maximum percentage replacement of river sand by Quarry dust and Marble powder in varying equal percentages 0%, 10%, 20%, 30%, 40%, 50%, and 60% for M25 mix designations.
whereas replacement of sand by marble waste powder up to 20% enhances the slump of the concrete mixes. In concrete production replacement of 5% cement by marble waste powder gives comparable compressive and flexural strength as of marble waste free concrete specimens, but increasing the replacement range beyond ...
Particles of this sand have smooth texture and are blackish. Sieve analysis was done to find out fineness modulus which comes out to be 3.14% which is under limit as per IS 383-1970. The test conducted on Sand is shown in Table No. 3. Table 3 Sand Marble powder Marble powder was collected from
in marble powder as replacement of cement as compared to normal concrete. But when they replaced sand with marble powder a consider increment in compressive strength was found at an optimum percentage of 20%. 4. Prof. Veena G. Pathan, Prof. Md. Gulfam Pathan , Feasibility and need of use of Waste marble powder in
May 18, 2015 But the split tensile strength decreased for the mix which contains 20 % marble powder dust against cement (10%) and sand (10%) by 11%. Hence result shows that marble powder when mixed with sand and cement together has low split strength as compared to the replacement of marble waste in cement and sand individually. 3.3 Durability.
Clay bricks were produced in 10 local fired clay brick kiln by partial replacement (1040%) of clay with calcined 11 and uncalcined waste marble powder. The temperature in the firing zone of the ...
Nov 12, 2012 pdf replacement of sand with marble powder in green concrete . The use of waste marble powder ( dust) was proposed in partial replacement replacement of cement with marble powder pdf. Production of Selfcompacting Concrete . More detailed.
Shahul Hameed et al (2012) have done the experiment to study the feasibility of the usage of quarry rock dust and The concept of replacement of natural fine aggregate by marble sludge powder as hundred percent substitutes for quarry dust improve the utilization of generated quarry natural sand in concrete.
marble powder and helps in preserving the ecosystem. Siva and Mallika 3 studied the possibility of utilizing marble dust in high-strength concrete mix. It was observed that maximum compressive strength would be achieved by 10% marble replacement. It was reported that replacement of cement and sand by marble powder up to 10% could increase the ...
Nov 22, 2019 This paper reports the experimental study which investigated the influence of 60% replacement of sand with quarry dust and marble powder. METHODOLOGY OBJECTIVE Investigation on dust quarry and marble powder on high strength concrete. Casting of the test specimen. Comparing the performance of concrete with normal concrete.
An ordinary Portland cement (CEM I 42.5) and a marble powder (MP) were used. The chemical and physical properties of cement and MP are given in Table 1. The sand used was a mixture of natural river sand (RS) and dune sand (DS). Selected sands are subjected to grain size distribution analysis as per XP P 18-540 standard (AFNOR, 1997).
the partial replacement with sand having 10% marble dust powder. But the split tensile strength decreased for the mix which contains 20 % marble powder dust against cement (10%) and sand (10%) by 11%. Hence result shows that marble powder when mixed with sand and cement together
Hence result increased by the value of 9.2% and for 10% replacement with shows that marble powder when mixed with sand and cement sand the flexure strength also got increased about 9.3% but it together has low compressive strength as compared to the decreased when the mix contains 20% marble powder dust replacement of marble waste in cement and ...
Influence of limestone waste as partial replacement material for sand and marble powder in concrete properties.pdf Available via license CC BY-NC-ND 3.0 Content may be subject to copyright.
Download full-text PDF ... The effect is found to be increased by the addition of WMP as a replacement of cement and on the replacement of sand it ... The use of waste marble powder in the ...
material which is partial replacement of cement with marble powder and sand with glass powder. In this concrete 10% of glass powder is commonly replaced by sand in optimum level and 0%, 10% 20% of marble powder replaced with cement respectively.
Kabeer Vyas (2018), replaced marble powder with fine aggregate in mortars. Four different mortar mixtures prepared to observe the influence of marble powder on fresh and hardened properties of mixture. They concluded that due to thixotropic property of marble powder, its replacement with river sand result with a reduction in water amount of the
increasing marble powder content when compared with control sample at each curing age. No mortar cube with partial replacement of marble granules conform to the standard of IS8112 1989. Surprisingly when sand is partial replaced by marble powder, all mortar cubes except that replacement of 20% does not conform to IS8112
Shirule et al studied the Partial Replacement of cement with Marble Dust Powder. It can be concluded that for M20 grade concrete The Compressive strength of Cubes are increased with addition of waste marble powder up to 10% replace by weight of cement and further any addition of waste marble powder the compressive strength decreases.
capacity, marble can be used as in the partial replacement of cement in mixture of sand-Cement. In this project work, collect the waste marble residue from the factories, plants and examine its outcome on the Sand-Cement mixture in various proportions and comparison the compression capacity of cement-sand mixture, durability and workability.
of sand replacement as compared to the cement replacement. Additional studies were conducted to evaluate the ef-fect of using granite waste as a replacement for cement and sand in the concrete and mortar mixes. Shehdeh (2016) observed that substitution of 10% of sand by weight with granite powder in concrete resulted in a maximum increase in ...
Based on the data, a mix design for M30 grade concrete is made and the replacement of cement with marble powder by 0%, 5%, 10%, 15%, 20% and 25% is considered. The proportions of the basic constituents of concrete for all the six mix ratios are presented
replacement are nearly equal to 37 which 13% less than the black cotton soil value. As same for 40% replacement liquid limits value decrease by 22% and for 50% marble powder it reduced by 36%. As same reduction is identified plastic limit and plasticity index. Reduction in plastic limit value for 30, 40, 50 % marble powder are respectively 9.03 ...
Jul 31, 2021 Marble powder was used as partial replacement of sand and cement at 0, 25, 50, 75 and 100% by 6 and 7 with 10% fly ash, 10 %slag, 7.5% silica fume and 1% superplasticizer in concrete.
Feb 04, 2020 For sand replacement, and by replacing 10% of sand with marble powder in (NF10), the compressive strength value rises up to 5% above the control CM. Replacing 5% of cement and 10% of sand with marble waste powder in NC5 NF10 mix gives almost the same compressive strength value obtained from CM.
Marble Powder (MP) The 25% of marble powder is produced during the cutting and polishing of marble blocks. Around 7,000,000 tons of marble have been delivered on the planet. Today, disposal of marble powder is the ecological issue in marble business. Fine Aggregate Locally available sand was used as fine aggregate of size 4.75mm.
The evaluation of Marble Dust Powder for use as a replacement of cement material begins with the concrete testing. The study is conducted to analyze the compressive strength of concrete when the base materials, i.e. cement is replaced with marble dust powder respectively. The marble dust powder replacement was
10% marble powder as partial replacement of cement and MX3 with 15% marble powder as partial replacement of sand, MX4 with 15% marble powder as partial replacement of cement and also MX5 with 20% marble powder as partial replacement of cement and sand together and MX6 with 30% marble powder dust as partial replacement of cement and sand ...
fine aggregate (sand) and cement were partially replaced with Granite powder and marble powder. The replacement is done by 5%, 10%, 15%, 20%, 25% of cement by marble powder and 5%, 10%, 15%, 20%, 25% of fine aggregate by granite powder to evaluate the effect of presence of these replacement materials on the strength of specimens.
replacement of sand by waste plastic, is minimal and can be enhanced by addition of superplasticizer. ... the amount of marble powder as a replacement of y ash. Binici et al. 7 found that marble dust concrete had higher compressive strength than that of the corresponding lime
concrete tile with marble waste produces a lighter weight 3.6 % - 12.3 % replacement of PC with marble powder by 20 % qualify flexural strength , water absorption ( no more than 10 % ) and there is no seepage within 20 hours 5 minutes .They
Marble Powder As A Partial Replacement Of Sand. V. CONCLUSION From the test results it is clearly evident that granite powder as a partial replacement of sand proves to be beneficial when Durability properties of Concrete is considered. Durability of Concrete using Granite Fines is almost same as that of reference mix (GF0), However at 30% ...